Install Your Tuners

This section will give you some basic ideas on how to get your tuner working with your operating system. However, it’s clearly way beyond the scope of this guide to tell you everything: consult specialist forums, search around, and at least do some research to work out what’s likely to work or not before you hand over any money.

There is a discussion about supported hardware on the Tvheadend forums.

1. Install the Tuner Hardware

This is obviously a core requirement that’s outside of the scope of this guide

You basically have the choice of:

  • External USB tuners that plug in

  • Internal (e.g. PCI) tuners that go inside the computer chassis

  • External SAT>IP tuners that send their decoded signals over a LAN connection.

Follow the appropriate installation instructions and, if relevant, the setup instruction (e.g. for SAT>IP, which are effectively small, standalone computers).

A Note on USB Tuners

USB tuners are cheap, work well and are frequently well-matched to physically-smaller builds (e.g. HTPCs) which simply don't have the internal slots. However, please remember that many need external power, or need a powered hub to work properly.

In addition, even USB3 doesn't have the greatest practical bandwidth per bus. That means you're probably asking for problems if you have four DVB-S2 dongles on the same USB connection to the motherboard.

2. Install Firmware and/or Drivers

Similar to the above, Tvheadend can do nothing if your tuners aren’t working properly. A good place to check how to set up your tuners is the LinuxTV wiki device library - this will not only tell you what’s supported under Linux, but also how to get it all working.

Many tuners require firmware - normally, a binary file that’s been extracted from the proprietary drivers used by Windows. Many Linux distros include a package for the most common devices (e.g. linux-firmwares under Ubuntu or firmware-linux-nonfree under Debian). If this isn’t sufficient, a good source of firmware files is the OpenElec firmware library on their git repository.

Typically, download the binary file and install it into /lib/firmware, owned by root:root, permissions rw-r--r-- (0644)